Epson MOVERIO BT-200 User Manual page 39

01_Chapter title
01_Head A
FCC Compliance This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Statement These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
02__lead
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular instal-
lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
WARNING
The connection of a non-shielded equipment interface cable to this equipment will invalidate the FCC Certification or Declaration of
this device and may cause interference levels which exceed the limits established by the FCC for this equipment. It is the responsibil-
ity of the user to obtain and use a shielded equipment interface cable with this device. If this equipment has more than one interface
connector, do not leave cables connected to unused interfaces. Changes or modifications not expressly approved by the manufac-
turer could void the user's authority to operate the equipment.
FCC Notices
FCC/Industry Can-
ada (IC) Notices This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause unde-
sired operation.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. End-users must follow the
specific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in con-
junction with any other antenna or transmitter.
Caution:
You are cautioned that changes or modifications not expressly approved by the party responsible for compliance could void your
authority to operate the equipment.
Industry Canada (IC) Notices
CAN ICES-3 (B)/NMB-3(B)
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numèrique de la classe B est conforme à la norme NMB-003 du Canada.
This equipment complies with RF radiation exposure limits set forth for an uncontrolled environment. End-users must follow the spe-
cific operating instructions for satisfying RF exposure compliance. This transmitter must not be co-located or operating in conjunc-
tion with any other antenna or transmitter.
General Notes
39 39