Maytag YMHWE251 Series Use & Care Manual page 8

Front-loading automatic washer
Table of Contents

Advertisement

Available languages

Available languages

CYCLE GUIDE — SPECIAL-PURPOSE CYCLES
Settings and options shown in bold are default settings for that cycle. For best fabric care, choose the cycle that best fits the
load being washed. Not all cycles and options are available on all models.
For best performance, not all settings are available with each cycle, and some options cannot be used together.
Items to wash
Cycle:
using default cycle
settings:
Swimwear, items that
Rinse/Drain
need rinsing only.
& Spin
Wet load of clothes
Rinse/Drain
& Spin
All loads
No clothes in washer
Clean
Washer with
affresh
* All temperature selections feature a cold rinse.
Load Size Recommendations
NOTE: A single item, bulky items, or tightly packing may cause imbalance. Add items or try to evenly distribute wet laundry in
the drum, and start a Rinse/Drain & Spin cycle. If the laundry is still wet, take half of the load out of the washer and try again.
For best results, follow the load size recommendations noted for each cycle.
Small load: Fill the washer drum with 3-5 items, not more than 1/4 full.
Medium load: Fill the washer drum up to about 1/2 full.
Large load: Fill the washer drum up to about 3/4 full.
Extra-large load: Fill the washer drum, but make sure clothes can tumble freely.
For best results, avoid packing tightly.
8
Wash
Spin
Temp.*:
Speed:
Cold
Ex High
High
Medium
Low
N/A
Ex High
High
Medium
Low
Warm
Soak
No Spin
Cold
High
N/A
®
Soil
Available
Level:
Options:
Delay Start
2nd Rinse
Cycle Signal
Fresh Spin™
Delay Start
2nd Rinse
Cycle Signal
Fresh Spin™
Delay Start
Cycle Signal
Delay Start
Cycle Signal
Cycle Details:
This cycle adds water followed by a
high-speed tumbling. For some fabrics
you may wish to set the spin speed to
a lower setting.
To use Rinse/Drain & Spin deselect 2nd
Rinse option. Use this cycle to get water
extracted from clothes or you want
additional extraction on a washed load.
Using Drain & Spin. Use this cycle with
medium and large loads.
This cycle provides a soak with short
tumbling phase and a soaking time
that help improve the removal of stains,
without drum followed by drain. Drain
without spin assures gentle treatment.
Use this cycle every 30 washes to keep the
inside of your washer fresh and clean. This
cycle uses a higher water level. Use with
affresh
Washer Cleaner tablet or liquid chlorine
®
bleach to thoroughly clean the inside of your
washer. This cycle should not be interrupted.
See "Washer Care."
IMPORTANT: Do not place garments or other
items in the washer during the Clean Washer
with affresh
cycle. Use this cycle with an
®
empty wash tub.

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ymhwe201 seriesYmhwe301 series

Table of Contents