Installation - Westinghouse GON474 Owner's Manual

I N S TA L L AT I O N
USE AN AUTHORISED PERSON
As stated in the local municipal building codes and other relevant statutory regulations.
• Refer to data plate for rating information and circuit diagram. The data plate is positioned
behind the bottom of the oven door. The circuit diagram is positioned on the top panel of
the appliance.
IMPORTANT: This appliance must be properly earthed.
• Do not lift the appliance by the door handles.
• Prepare the cupboard opening to match your appliance measurements. (See diagrams).
• Slide appliance into the cupboard, ensuring that the supply cable (where fitted) does not
kink.
• To prevent tipping, use the screws supplied to secure your oven into the cupboard. Use just
2 screws for underbench and separate grill underbench ovens, and 4 screws for separate
grill wallovens. Remove the bottom door in separate grill wallovens to provide access to
the bottom 2 screwing points (see illustrations on page 26 & 27).
• For appliances fitted with a supply flexible cord, if the cord is damaged, it must be
replaced by the manufacturer or its service agent or similarly qualified person in order to
avoid a hazard. The plug must be accessible after installation.
• Where the appliance is built into a cabinet, the cabinet material must be capable of
withstanding 70°C. Installation into low temperature tolerant cabinetry (e.g. vinyl coated)
may result in deterioration of the low temperature coating by discolouring or bubbling.
• If the appliance is installed adjacent to vinyl-wrapped surfaces, use an installation kit
available from the vinyl-wrap supplier.
• Electrolux Home Products cannot accept responsibility for damage caused by installation
into low temperature tolerant cabinets.
• After installation, test and ensure that the appliance operates correctly before handing it
over to the customer.
It is recommended that this product is not installed in an unvented living space, particularly
if that space incorporates sleeping quarters.
CAUTION: To avoid any potential hazard, you must follow our instructions below
when you install your appliance. Failure to install the appliance correctly could
invalidate any warranty or liability claims and lead to prosecution.
This appliance is only suitable for connection to fixed consumer piping where the fault
pressure is limited to 14kPa or less.
Refer clause 4.6.1 of A.S. 5601.
22