Replacing The Power Supply - Lenovo 3000 Hardware Maintenance Manual

Replacing the power supply

This procedure describes how to remove and replace the power supply.
10. Go to "Completing the FRU replacement" on page 161.
1. Remove the computer cover. See "Removing the cover" on page 123.
Note: For this procedure, it helps to lay the computer on its side.
2. Disconnect the power supply cables from the system board and from all
drives.
3. Remove the four screws that secure the power supply at the rear of the
chassis.
4. Lift the power supply out of the chassis.
5. If the power supply has a voltage-selection switch, ensure that it is set to
match the voltage available at the electrical outlet.
v If the voltage supply range in your local country or region is 100-127 V ac,
set the switch to 115 V.
v If the voltage supply range in your local country or region is 200-240 V ac,
set the switch to 230 V.
6. Install the new power supply into the chassis so that the screw holes in the
power supply align with those in the chassis.
7. Install the four screws to secure the power supply.
Note: Use only the screws provided by Lenovo.
8. Reconnect the power supply connectors to the system board. See "Locating
parts on the system board" on page 125.
9. Reconnect a power supply connector to each of the drives.
Chapter 9. Replacing FRUs - Tower Computers
129