Ariens 926310-ST9526DLE Owner's/Operator's Manual page 25

Auger Shaft
NOTE: To grease auger shaft, remove shear
bolt nuts, and shear bolts. Apply grease at the
grease zerks and then turn the auger shaft.
Replace shear bolts per instructions in Shear
Bolts on page 26.
Grease
Oil
OS7135
Figure 20
Clean Battery (926312, 313, 316)
WARNING: AVOID INJURY. Read
and understand the entire Safety
section before proceeding.
IMPORTANT: Battery is maintenance-free.
Do not tamper with or attempt to open battery.
See SERVICE AND ADJUSTMENTS on
page 26 for charging procedures.
Terminals
Keep battery and its terminals clean.
IMPORTANT: Remove battery from unit
before cleaning.
OS0642
OS7140
OS7145
Remove corrosion from battery terminals and
cable connections with a wire brush, then
wash with a weak baking soda solution.
After cleaning, apply a thin coat of grease or
petroleum jelly to terminals and cable ends to
retard corrosion.
Replace Fuse (926312, 313, 316)
1. Remove the two screws and the cover
plate from beneath the battery.
Cover plate and
mounting screws.
2. Locate the fuse holder on the wiring
harness and remove the fuse.
3. Install a new fuse of the same amp-
rating and type.
GB - 25
Figure 21
OS7450