What To Do If - Zanussi ZKG44500X User Manual

Notes on cleaning:
• Clean the front of the appliance with a soft
cloth with warm water and a cleaning agent.
• To clean metal surfaces, use a usual clean-
ing agent.
• Clean the appliance interior after each use.
Then you can remove dirt more easily and it
does not burn on.
• Clean stubborn dirt with a special oven
cleaner.
• Clean all accessories after each use and let
them dry. Use a soft cloth with warm water
and a cleaning agent.
• If you have nonstick accessories, do not
clean them using aggressive agents, sharp-
edged objects or a dishwasher. It can cause
damage to the nonstick coating.
Shelf support
Removing the shelf support
You can remove the shelf support to clean the
side walls.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
www.zanussi.com
1
3
2
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic cut-out is activa-
ted.
1. Carefully pull the supports up and out of
the front catch.
2. Lightly move the supports on the front
catch inwards.
3. Pull the supports out of the rear catch.
Installing the shelf support
To install the shelf support follow the proce-
dure in the opposite order.
Lamp
Warning! There is a risk of electrical
shock.
The lamp and the lamp glass cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or de-
activate the circuit breaker.
Caution! Put a cloth on the bottom of the
interior of the appliance. It prevents
damage to the lamp glass cover and the
cavity.
Always use the same lamp type.
Replacing the lamp at the cavity ceiling:
1. Turn the lamp glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Activate the appliance.
Set the clock. Refer to "Setting
the clock".
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Remedy
19