What To Do If - Zanussi ZKC44510X User Manual

1. Carefully pull the supports up and out of
the front catch.
2. Lightly move the supports on the front
catch inwards.
3. Pull the supports out of the rear catch.
Installing the shelf support
To install the shelf support follow the procedure
in the opposite order.
Lamp
Warning! There is a risk of electrical
shock.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The lamp does not operate.
The display shows an error code
that is not on this list.
www.zanussi.com
1
3
2
Possible cause
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The automatic cut-out is activa-
ted.
The fuse is released.
The lamp is defective.
There is an electrical fault.
The lamp and the lamp glass cover can be hot.
Before you change the lamp:
• Deactivate the appliance.
• Remove the fuses from the fuse box or deac-
tivate the circuit breaker.
Caution! Put a cloth on the bottom of the
interior of the appliance. It prevents
damage to the lamp glass cover and the cavity.
Always use the same lamp type.
Replacing the lamp at the cavity ceiling:
1. Turn the lamp glass cover counterclock-
wise to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Activate the appliance.
Set the clock. Refer to "Setting the
clock".
Make sure that the settings are
correct.
Refer to "Automatic switch-off".
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Replace the lamp.
• Deactivate the appliance with
the house fuse or the safety
switch in the fuse box and acti-
vate it again.
• If the display shows the error
code again, contact the Cus-
tomer Care Department.
Remedy
27