Zanussi ZDV 12001 User Manual page 11

Alarm code
• The indicator of the set programme flashes contin-
uously.
• The end indicator flashes 3 times intermittently.
Warning! Deactivate the appliance before
you do the check.
Problem
The programme does not
start.
The appliance does not fill
with water.
The appliance does not
drain the water.
After the checks are completed, activate the
appliance. The programme continues from the
point of interruption.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
www.zanussi.com
Possible cause
The mains plug is not connected in
the mains socket.
The appliance door is open.
The fuse in the fuse box is damaged.
The water tap is closed.
The water pressure is too low.
The water tap is clogged or there is
limescale on it.
The filter in the water inlet hose is
clogged.
The water inlet hose has a kink or a
bend.
The anti-flood device is on. There are
water leakages in the appliance.
The sink spigot is clogged.
The water drain hose has a kink or a
bend.
Possible cause
The filters are clogged.
The filters are not correctly assem-
bled and installed.
The spray arms are clogged.
The programme was not applicable
for the type of load and soil.
Problem
The anti-flood device is on.
Connect the mains plug.
Close the appliance door.
Replace the fuse.
Open the water tap.
Contact your local water authority.
Clean the water tap.
Clean the filter.
Make sure that the position of the
hose is correct.
Close the water tap and contact the
Service.
Clean the sink spigot.
Make sure that the position of the
hose is correct.
If the problem occurs again, contact the Serv-
ice.
If other alarm codes show, contact the Service.
Clean the filters.
Make sure that the filters are correctly
assembled and installed.
Remove remaining soil with a thin
pointed object.
Make sure that the programme is ap-
plicable for the type of load and soil.
Possible solution
Possible solution
11