Electrical Connection; Technical Specification - Electrolux ER 8124 I Installation And Instruction Manual

Open both the appliance door and that of the Fig. 9
kitchen unit to approx. 90°. Place the little plates
8mm
over the runners. Hold the doors of the appli-
ance and the unit together and mark the holes.
PR34
Remove the little plates and make the holes
with a diam. of 2 mm. Replace the little platee
Fig. 10
over the runners and screw in the screws
provided (3.5x16 mm).
For the alignment of the kitchen unit door, if
necessary, use the clearance size of the slotted
holes. At the end of the procedure, check that
the doors of the appliance and the kitchen unit
open properly.
PR35
If the appliance is fixed to the side of the kitchen
Fig. 11
unit, simply slacken the screws in the fixing
brackets (G), move the brackets as shown in
the figure and re-tighten the screws.
E
E
D735

Electrical connection

Before plugging in, ensure that the voltage and frequency shown on the serial number plate
correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For
operation with different voltages, a suitably sized auto-transformer must be used.
TECHNICAL SPECIFICATIONS
GB
The technical data is indicated in the rating plate on the left side inside the appliance.
42