Preparing The Jet Clean System For Use - Philips PT927 User Manual

English
14
8 Insert the lug of the shaving unit into the slot in the top of the shaver.
Then close the shaving unit.
Note: If the shaving unit does not close smoothly, check if you have inserted
the shaving heads properly and if the retaining frame is locked.
Cleaning the shaving unit in the Jet Clean system (PT927CC/
PT923CC only)
The Jet Clean System cleans the shaving unit.

Preparing the Jet Clean system for use

Note: Fill the cleaning chamber before first use and when the 'fluid low' symbol
flashes to indicate that the fluid level is too low. When the fluid level drops
below the minimum level, the cleaning symbol and the 'fluid low' symbol start
to flash and the shaver holder returns to its starting position
1 Simultaneously press the release buttons on both sides of the
cleaning chamber (A). Then lift the Jet Clean System off the cleaning
chamber (B).
The cleaning chamber remains behind.
,
2 Unscrew the cap from the bottle with Jet Clean solution
(HQ200) and remove the airtight seal.
3 Fill the cleaning chamber with Jet Clean solution (HQ200) up to the
MAX indication.
Note: Make sure the cleaning chamber is always filled above the MIN
indication.
4 Place the Jet Clean System back onto the cleaning chamber ('click').
Make sure that the release buttons snap back into place.
When the cleaning chamber is filled with Jet Clean solution, do not move
it to prevent leakage.