LS 400Xi Product Reference Guide
What If...
Nothing happens when you follow the operating instructions?
You Should
Check the system power. Is there a battery in the battery box?
t
Be sure the scanner is programmed for the terminal in use.
t
Make sure the scanner is programmed to read the type of bar code you are scanning.
t
Check for loose cable connections.
t
Check the symbol to make sure it is not defaced.
t
Try scanning test symbols of the same code type.
t
Symbol is decoded, but not transmitted to the host terminal?
You Should
Be sure the proper host type is selected (See
t
Scanned data is incorrectly displayed on the terminal?
You Should
Make sure the system is programmed for the correct keyboard type.
t
Make sure the CAPS LOCK key is off.
t
Be sure the proper host is selected.
t
Be sure editing options (e.g., UPC-E to UPC-A Conversion) are properly
t
programmed.
Note: If after performing these checks the symbol still does not scan, contact
your distributor or call the
the telephone number.
3-4
Chapter
5).
Symbol Support
Center. See
page ii
for