Table of Contents
Advertisement
Scanning 1-D Bar Codes
To scan a 1-D bar code:
1. Make sure all connections are secure, and the symbol you want to scan is within the
scanning range (refer to
2. Aim the scanner at the symbol and press the trigger. The scanning beam remains on
for approximately 3.0 seconds (default) or until a successful decode.
The scanner has read the symbol when:
You hear a short, high tone beep (if the beeper is enabled).
t
The yellow LED on the rear of the scanner turns green.
t
The green LED stays lit for two seconds or until the next trigger pull.
Chapter 3
Scanning
Technical Specifications on page
4-2).
3-1
Advertisement
Table of Contents
