HP 1080p User Manual page 28

If using the TV ANT/Cable connector:
■
Connect the signal source to the ANT/Cable
■
connector. See "Connecting the cable TV or
air broadcast antenna" on page 10.
Connect audio cables from the TV Audio
■
Output (either digital optical or analog stereo,
or both) to the home theater input.
If the home theater does not support Digital
■
Dolby, set the digital audio format in the
onscreen display Audio menu Digital Audio
option to PCM. See "Choosing the digital
audio output mode" on page 54.
To program the TV universal remote to control all the
devices, see "Programming the Remote Control for a
Home Entertainment Device" on page 43.
A/V receiver system (with video
pass-through)
When you have an A/V receiver system with video
pass-through, do the following:
Route the audio and video from all source devices
■
to the A/V receiver.
For HDMI source devices, you may need to use a
■
separate digital audio cable in addition to the
HDMI cable.
Use a single video cable from the A/V receiver to
■
the TV.
Use the TV remote control to select the input
■
source (Source button) where you've connected
the A/V receiver.
Use the A/V receiver remote control to select the
■
video source device.
18
HP MediaSmart HDTV User Guide
Use the source device remote control to control
■
playback.
If using the TV ANT/Cable connector:
■
Connect the signal source to the ANT/Cable
■
connector. See "Connecting the cable TV or
air broadcast antenna" on page 10.
Connect cables from the TV Audio Output
■
(either digital optical or analog stereo, or
both) to the A/V receiver input.
If the A/V receiver does not support Digital
■
Dolby, set the digital audio format in the
onscreen display Audio menu Digital Audio
option to PCM. See "Choosing the digital
audio output mode" on page 54.
To program the TV universal remote to control all the
devices, see "Programming the Remote Control for a
Home Entertainment Device" on page 43.
Powered speakers or amplifier
When you have powered speakers or a stereo
amplifier, do the following:
Route the audio and video from all source devices
■
to the TV.
Connect audio cables from the TV Audio Output
■
(either digital optical or analog stereo, or both) to
the powered speakers or amplifier input.
Use the TV remote control to select the input
■
source (Source button).
Set the digital audio format in the onscreen
■
display Audio menu Digital Audio option to PCM.
See "Choosing the digital audio output mode" on
page 54.