Operation - Black & Decker BDH1760SM Instruction Manual

SWItCHINg oN aND off - fig. J
CautIoN:
Do Not uSe tHe uNIt uPSIDe DoWN.
NotICe:
When the steam mop is first
turned on the water reservoir will glow red.
Once the steam mop is ready to use the water
reservoir will glow blue. It takes approximately
15 seconds for the steam mop to heat up.
• To switch the appliance on, press the ON/
OFF button (1).
• To switch the appliance off, press the ON/
OFF button.
NotICe:
Never leave the steam mop in one spot on any surface for any period of time.
Always place the steam mop on the resting mat (7) with the handle tube (4) in the upright
position when stationary and make sure the steam mop is turned off when not in use.
NotICe:
Always empty the water tank after use.
SmartSelect
tm
The steam mop is equipped with a
SmartSelect dial (20) which shows various
TM
hard floor surface cleaning applications.
A Light will glow next to the selected
application. To change the application, press
and release the SmartSelect
repeatedly until the light glows next to the
correct operating mode for your particular
hard floor surface.
NotICe:
Do not use on any unsealed
hard floor surfaces. Additionally, on surfaces
that have been treated with wax or some no
wax floors, the sheen may be removed by the heat and steam action. It is always
recommended to test an isolated area of the surface to be cleaned before proceeding.
We also recommend that you check the use and care instructions from the floor
manufacturer.
using the SmartSelect
The steam mop will select the correct volume of steam required for your particular
cleaning operation.
NotICe:
SmartSelect
previously used setting.
Steam burSt buttoN - fig. k
The steam burst button is a built in feature that aids in the removal of stubborn floor marks or
stuck on grime.
• To apply an extra burst of steam to trouble areas, press the Steam Burst button (19).
NotICe:
The steam burst will last for 10 seconds then the steam mop will return to
the chosen setting.
for floor uSe oNly;
Dial - fig. k
button (2)
TM
button (2), choose from one of the following applications:
tm
tm
has a memory. Switching the steam mop on will recall the

oPeratIoN

J
k
20
7