Internal Packaging - Electrolux ESE6107 User Manual

10
INSTaLLaTIoN
3. If the cabinet is level, then the side walls should be
plumb or vertical. If the cabinet is built in or partly
built in check the alignment of the cabinet side
against the cupboard.
aligned to cupboard –
even gap
4. If the appliance now rocks from one corner to the
opposite rear corner, this means that the floor is
uneven; you will need to put some packing under
one of the rear rollers.
5. You may now need to fine-tune the installation by
adjusting the front rollers once again.
adjusting the door alignment
Each door is independently adjustable in the vertical
direction by turning the adjustable bolts under the hinges
using the spanner provided.
The doors can be adjusted up or down. Depending on
the amount of adjustment required it may be sufficient to
adjust only one door (refer to following diagrams).
Large plastic roller nut
NOTE: When the height of the rollers and adjusting bolts
are correctly adjusted the refrigerator will stand firmly on
the floor and the doors will be in line with one another.
Top of refrigerator
is level – horizontal
adjust front rollers for
unevenness of floor. e.g.
adjust this roller down.
Packing may be required
underneath the rear roller
to ensure stability.
adjusting bolt
front roller
Spanner

internal packaging

1. Please remove all internal packaging material before
use. any glue or tape residue or the like should be
removed with a solution of mild detergent and water.
2. Clean your appliance thoroughly following the
instructions in the 'Cleaning your refrigerator' section
and wipe off any dust that has accumulated
during shipping.
3. It is recommended that the refrigerator is kept upright
at all times. however if for any reason the refrigerator
is laid down, let it stand for a minimum of 1 hour
before turning on.
Warning!
Before cleaning: remove the power cord from the
power socket. This will make sure there is no chance
of getting an electric shock.
4. Install accessories such as the egg tray. The
accessories are packed together to prevent damage
during delivery.
5. Plug your appliance into the power point.
6. We recommend that you let your refrigerator run
for two to three hours before you put any food in it.
This will allow you to check that it is operating properly
and that enough cool air is circulating.
Spanner