Advertisement
Adjusting the depth of cut
Loosen the screw on the depth guide and move the base up or down. You can read the
depth of cut by aligning the top of the notch in the depth guide with the graduations on
i t s
right side. (Note: This can be done for
0"
bevel cutting only.) At the desired depth of
cut, secure the base by tightening the screw.
Base
Screw
Top of
notch
Fig.
13
Fig. 14
CAUTION
:
Use
a
shallow depth of cut when cutting thin workpiece for cleaner, safer cuts.
0
After adjusting the depth of cut, always tighten the screw securely.
Bevel cutting
Loosen the screw on the bevel scale plate
on the front of the base. Set for the desired
angle
(0"
-45") by tilting accordingly, then
the screw securely.
Bevel
scale plate
Fig.
15
CAUTION
:
After adjusting the depth of cut and bevel cutting angle, be sure to tighten the screw.
12
Advertisement
