Related Manuals for Makita 5008MGJ/2
Summary of Contents for Makita 5008MGJ/2
- Page 1 INSTRUCTION MANUAL Circular Saw 5008MG 5008MGA 008185 DOUBLE INSULATION IMPORTANT: Read Before Using.
-
Page 2: Specifications
Vibration emission (a ) : 3.0 m/s wood while in firm contact with the workpiece. With Uncertainty (K) : 1.5 m/s appropriate Makita genuine saw blades, other materials can also be sawed. Work mode : cutting metal ENF002-2 Vibration emission (a ) : 3.0 m/s... -
Page 3: General Power Tool Safety Warnings
Avoid body contact with earthed or grounded EC Declaration of Conformity surfaces such as pipes, radiators, ranges and Makita declares that the following Machine(s): refrigerators. There is an increased risk of Designation of Machine: electric shock if your body is earthed or grounded. -
Page 4: Circular Saw Safety Warnings
14. Remove any adjusting key or wrench before 26. Follow instruction lubricating turning the power tool on. A wrench or a key left changing accessories. attached to a rotating part of the power tool may 27. Keep handles dry, clean and free from oil and result in personal injury. - Page 5 Kickback causes and related warnings − kickback is a sudden reaction to a pinched, bound or misaligned saw blade, causing an uncontrolled saw to lift up and out of the workpiece toward the operator; − when the blade is pinched or bound tightly by the kerf closing down, the blade stalls and the motor reaction drives the unit rapidly back toward the operator;...
- Page 6 19. Check the operation of the lower guard spring. If the guard and the spring are not operating Fig.1 properly, they must be serviced before use. Lower guard may operate sluggishly due to damaged parts, gummy deposits, or a build-up of debris.
-
Page 7: Functional Description
32. Only use the saw blade with the diameter that FUNCTIONAL DESCRIPTION is marked on the tool or specified in the manual. Use of an incorrectly sized blade may affect the proper guarding of the blade or guard CAUTION: operation which could result in serious personal Always be sure that the tool is switched off and unplugged •... -
Page 8: Switch Action
2. Shaft lock Lighting the lamp 1. Lamp 007330 CAUTION: Be sure the blade is installed with teeth pointing up • at the front of the tool. 007351 Use only the Makita wrench to install or remove the • blade. -
Page 9: Operation
When you wish to perform clean cutting operation, the side of the workpiece and secure it in position with connect a Makita vacuum cleaner to your tool. Install the the screw on the front of the base. It also makes joint on the tool using the screws. -
Page 10: Optional Accessories
1. Base minutes. Then check the tool while running and electric 2. Adjusting screw brake operation when releasing the switch trigger. If electric brake is not working well, ask your local Makita service center for repair. OPTIONAL ACCESSORIES CAUTION: 007332... - Page 12 Makita Jan-Baptist Vinkstraat 2, 3070, Belgium Makita Corporation Anjo, Aichi, Japan www.makita.com 884738E229...