What To Do If - Zanussi ZOF35501 User Manual

3. Hold the door glass panels on their top
edge one by one and pull them upwards
out of the guide
4. Clean the door glass panels.
To install panels follow the procedure in
reverse. Insert the smaller panel first, then
the larger.
Oven lamp
Warning! There is a danger of electrical
shock!
Before you change the oven lamp:
• Switch off the oven.

What to do if...

Warning! Refer to the Safety chapters.
Problem
The cooking zones do not oper-
ate.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The appliance does not heat up.
The amp does not operate.
Steam and condensation settle
on the food and in the appliance
cavity.
The display shows "12.00".
www.zanussi.com
• Remove the fuses in the fuse box or switch
off the circuit breaker.
cover.
Replacing the oven lamp
1. You can find the lamp glass cover at the
2. Clean the glass cover.
3. Replace the oven lamp with applicable
Important! Use the same oven lamp type.
4. Install the glass cover.
Possible cause
Refer to the operating instructions for the built-in cooking surface.
The appliance is deactivated.
The clock is not set.
The necessary settings are not
set.
The fuse is released.
The lamp is defective.
You left the dish in the appliance
for too long.
A power cut.
Put a cloth on the bottom of the oven for
protection of the oven light and glass
back of the cavity.
Turn the lamp glass cover counterclock-
wise to remove it.
300°C heat-resistant oven lamp.
Activate the appliance.
Set the clock.
Control the settings.
Make sure that the fuse is the
cause of the malfunction. If the
fuse releases again and again,
contact a qualified electrician.
Replace the lamp.
Do not leave the dishes in the ap-
pliance for longer than 15 - 20
minutes after the cooking process
ends.
Reset the clock.
Remedy
17