NETGEAR CBVG834G Adminstrators User Manual page 24

Wireless Cable Voice Gateway Model CBVG834G Adminstrators User Manual
The following table explains the settings in the Basic Settings screen.
Table 1-2. Basic Settings
Settings
Network WAN IP Address
Configuration
WAN Subnet Mask
WAN Default Gateway
Primary DNS
Secondary DNS
Cable Network DHCP
Settings
Static
L2TP (DHCP)
L2TP (static)
1-10
Description
This is the current configuration for the WAN side of your
gateway.
The ISP router to which your gateway will connect.
The DNS server is a host on the Internet that translates
Internet names (such as
numeric IP addresses. Typically your ISP transfers the IP
address of one or two DNS servers to your gateway during
login. If the ISP does not transfer an address, you must
obtain it from the ISP and enter it manually. If you enter an
address here, you should reboot your PCs after configuring
the gateway.
You can specify a secondary DNS server in this field.
If your service provider assigns your IP address through
DHCP, use this default setting.
If your service provider assigned you a permanent, fixed
(static) IP address for your PC, select Static. Fill in the
following fields:
• Static IP Address (also known as the netmask)
• Static IP Mask
• Default Gateway
• Primary DNS
• Secondary DNS
Use this setting for a layer two tunnelling protocol with
DHCP. Then fill in the following fields:
• PPP User Name
• PPP Password
• L2TP Server
Use this setting for a layer two tunneling protocol with a
static IP address. Then fill in the following fields:
• Static IP Address (also known as the netmask)
• Static IP Mask
• Default Gateway
• PPP User Name
• PPP Password
• L2TP Server
v1.0, February 2008
http://www.netgear.com
Installing the Gateway
) to