Epa Energy Star Compliance; Power Cord Set Requirements - HP Series v72 User Manual

Agency Regulatory Notices

EPA Energy Star Compliance

Monitors that are marked with the Energy Star
requirements of the EPA Energy Star program. As an Energy Star
Partner, Hewlett-Packard Company has determined that this
product meets the Energy Star guidelines for energy efficiency.
Specific details on using the Energy Saving features can be found
in the energy saver or power management section of the computer
manual.

Power Cord Set Requirements

The monitor power supply is provided with Automatic Line
Switching (ALS). This feature allows the monitor to operate on
input voltages between 100–120V
The power cord set (flexible cord or wall plug) received with the
monitor meets the requirements for use in the country/region
where you purchased the equipment.
If you need to obtain a power cord for a different country/region,
you should purchase a power cord that is approved for use in that
country/region.
The power cord must be rated for the product and for the voltage
and current marked on the product's electrical ratings label. The
voltage and current rating of the cord should be greater than the
voltage and current rating marked on the product. In addition, the
cross-sectional area of the wire must be a minimum of 0.75 mm²
or 18AWG, and the length of the cord must be between 6 feet
(1.8 m) and 12 feet (3.6 m). If you have questions about the type
of power cord to use, contact your HP authorized service provider.
A power cord should be routed so that it is not likely to be walked
on or pinched by items placed upon it or against it. Particular
attention should be paid to the plug, electrical outlet, and the point
where the cord exits from the product.
C–4
®
Logo meet the
or 200–240V .
User's Guide