Table of Contents
Advertisement
Your D
WALT tool is double insulated in
E
accordance with EN 50144; therefore no
earth wire is required.
Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor
size is 1.5 mm
2
.
When using a cable reel, always unwind the cable
completely.
Also refer to the table below.
2
Conductor size (mm
)
0.75
1.00
1.50
2.50
4.00
Voltage
Amperes
115
- 2.0
0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
230
0 - 2.0
2.1 - 3.4
3.5 - 5.0
5.1 - 7.0
7.1 - 12.0
12.1 - 20.0
Assembly and adjustment
Prior to assembly and adjustment always
unplug the tool.
Selecting the operating mode (fig. B1 & B2)
D25112(K) (fig. B1)
The tool can be used in the following operating modes:
Rotary drilling: for screwdriving and for
drilling into steel, wood and plastics
Cable rating (Amperes)
6
10
15
20
25
Cable length (m)
7.5
15
25
30
Cable rating (Amperes)
6
6
6
6
6
6
6
6
6
6
10
15
10
10
15
20
15
15
20
25
20
20
25
-
6
6
6
6
6
6
6
6
6
6
6
6
10
10
10
10
15
15
15
15
20
20
20
20
D25113K/D25114K/D25213K (fig. B2)
The tool can be used in the following operating modes:
0
45
60
• To select the operating mode, press the safety
6
1
lock (5) and rotate the mode selector switch (4)
15
15
until it points to the symbol of the required mode.
20
20
• Release the safety lock and check that the mode
20
25
selector switch is locked in place.
25
-
-
-
6
6
6
6
10
15
Indexing the chisel position
15
15
The chisel can be indexed and locked into 51
20
20
different positions.
25
-
• Rotate the mode selector switch (4) until it points
to the "bit rotation" position.
• Rotate the chisel in the desired position.
• Set the mode selector switch (4) to the
"hammering only" position.
• Twist the chisel until it locks in position.
Inserting and removing SDS-plus
(fig. C)
This tool uses SDS-plus
inset in fig. B for a cross-section of an SDS-plus
shank).
Hammer drilling: for concrete and
masonry drilling operations.
Rotary drilling: for screwdriving and for
drilling into steel, wood and plastics
Hammer drilling: for concrete and
masonry drilling operations.
Hammering only: for light chipping,
chiselling and demolition applications.
In this mode the tool can also be used as
a lever to free a jammed drill bit.
Bit rotation: non-working position used
only to rotate a flat chisel into the desired
position.
Do not select the operating mode when
the tool is running.
®
®
accessories (refer to the
E N G L I S H
accessories
®
bit
9
- Quick Links:
- Technical Data
Hide quick links:
Advertisement
Table of Contents
