Figure 3-3. Aligning the Tab.
4. Connect the headset to the
bottom of the remote. Insert
the remote into the base
(see Figure 3-4). Either side
may be used. The battery
charge indicator marked
with the 5 icon on the
base will light up. This will
be referred to as the front of
the base. Fully charge the
remote for 3 hours before
using.
Figure 3-4. Connecting the Headset.
3.2 Checking the System
Put the system in headset mode by
pressing once on the headset/
handset selector on top of the
base. The on-line indicator
marked on the base with the 4
icon will light. After 5 to 45
seconds, the on-line indicator on
the top of the remote will start to
flash (the base searches for an
open transmission channel only
on the first time). The system is
CHAPTER 3: Installation
now working. If the on-line
indicator does not flash, recheck
assembly (Figure 3-5).
Figure 3-5. Checking the Assembly.
3.3 Charging the Battery
The nickel-metal-hydride battery
(NiMH) for the remote is not
charged when delivered. To
charge, place the remote with the
battery in the base for at least 3
hours before making the
adjustments below.
13