Table of Contents
Advertisement
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH
2.4 GHZ WIRELESS REMOTE UNIT WITH HOOKSWITCH
3. Installation
3.1 Assembling the Base and
Connecting to the Telephone
1. Disconnect the handset
cord from the telephone
and connect it to the port
marked with the 0 icon at
the bottom of the base.
Connect one end of the
telephone interface cord to
the telephone handset port
and the other end to the
bottom of the base marked
with the 1 icon. Connect
the AC power adapter to the
port marked with the 2
icon at the bottom of the
base, and then to the power
outlet (Figure 3-1). Turn on
the power.
12
Figure 3-1. Connecting the Cords.
2. Mount the base by aligning
the tabs extending from the
bottom of the base with the
corresponding slots on the
stand. Turn clockwise until
secure. The 3 cords should
extend from the back of the
base. Align the center tab of
the headset stand with the
port on either side of the
base. Slide the ends of the
headset stand over the top
of the base until it locks into
place (Figure 3-2).
Figure 3-2. Mounting the Base.
3. Align the tab at the bottom
of the battery with the notch
on the back of the remote.
Push the battery flush
against the remote until it
clicks into place
(Figure 3-3).
Advertisement
Table of Contents
