Table of Contents
Advertisement
Add and register a handset/headset
The handsets and headset provided with your telephone system are already
registered. Each handset is assigned a number that displays on the handset.
Additional handsets registered to the telephone system are assigned numbers
in the sequential order. This telephone system accommodates up to devices,
including a maximum of two DECT 6.0 headsets. The telephone base recognizes
and counts a headset the same as a handset.
You can add new handsets (DS6071, purchased separately) to your telephone
system. Each handset must be registered with the telephone base before use.
When first purchased and properly charged, each expansion handset shows
To register HS, see manual. Charge the handset before registering it to the
telephone base.
To register a handset:
.
Place the new/non-registered handset in the telephone base.
The handset shows Registering... Please wait, then Handset X Registered
.
and you hear a beep when the registration process completes. The registration
process takes about 0 seconds to complete.
You can add one more cordless headset (IS6100, purchased separately) to
your telephone system. The headset must be registered with the telephone base
before use.
To register a headset:
Press and hold FIND HANDSET on the telephone base for about 4 seconds
.
until the IN USE light turns on. Then release the button.
.
Immediately place the new/non-registered headset on the telephone base. It
takes about 60 seconds to complete the registration process. Do not remove
until the IN USE light goes off.
Deregister handsets/headset
If you want to replace a handset/headset or reassign the designated handset
number of a registered handset, you must deregister all devices, including all
handsets and headsets. Then individually register each device again.
To deregister all devices:
Press and hold FIND HANDSET on the telephone base for about 0 seconds
.
until the IN USE light on the telephone base turns on and starts flashing.
Immediately press FIND HANDSET again. You must press FIND HANDSET
.
while the IN USE light is still flashing. The IN USE light flashes for approximately
five seconds.
All handsets show To register HS, see manual. when the deregistration
3.
process completes. The deregistration process takes about 0 seconds
to complete.
Troubleshooting
If you have difficulty with your telephone, please try the suggestions below. For customer
service, visit our website at www.vtechcanada.com or call 1 (800) 267-7377.
I cannot add and connect my cell phone to the telephone base.
•
Make sure you have cellular coverage.
•
Make sure your cell phone is compatible with your DS6673. Check the Bluetooth
compatibility list at www.vtechcanada.com.
•
Make sure the Bluetooth function of your cell phone is turned on. See the user's manual of
your cell phone for more information.
•
Make sure that your Bluetooth cell phone is not connected to any other Bluetooth device.
•
To connect your cell phone, make sure that your cell phone is connected and active on the
device list.
Remove VTech DS6673 from your cell phone's handsfree device history list (see the user's
•
manual of your cell phone for more information).
•
Carefully follow the pairing instructions on page 6 and make sure that your cell phone is not
connected to any other Bluetooth device.
•
Turn off your cell phone, then turn it on again.
For some cell phones, you must authorize VTech DS6673 device in your cell phone's
•
Bluetooth feature. See the user's manual of your cell phone for more information.
Manually connect your cell phone to VTech DS6673. Refer to the user's manual of your cell
•
phone for more information.
Do not place the handset
in the charger.
Hide quick links:
Advertisement
Table of Contents
