SonicWALL TZ 170 Getting Started Manual page 13

2. Change Password - Change the administrative password. This is the password for
the admin account.
Old Password
New Password
Confirm
Note:
Keep your new password in a safe place. If you lose your password, you will
have to reset the SonicWALL security appliance to factory settings and lose your
configuration. For instructions on resetting your SonicWALL security appliance,
refer to the SonicOS Standard Administrator's Guide.
Click Next.
3. Change Time Zone - Change the Time Zone setting to your local time zone.
Time Zone
Automatically
adjust clock for
daylight saving time
Note:
It is important that you set the time zone correctly before you register your
SonicWALL TZ 170 Wireless.
Click Next.
4. WAN Network Mode - The Setup Wizard automatically detects most networking
modes. If it does not detect a networking mode, you may have a static IP address.
See Procedure 1, "Collecting Internet Service Provider (ISP) Information" on page 5.
Confirm the selection or select the correct type of network connection for your
network.
Static IP
DHCP
PPPoE
Page 12
Should be populated with the default password, password.
Enter your new password.
Re-enter your new password.
Select the time zone for your location from the list.
Check this setting if you live in an area that observes Daylight
Saving Time.
Select Static IP if you want to give the SonicWALL TZ 170 Wire-
less a specific, unchanging IP address.
Select DHCP if your ISP assigns your computer a dynamic IP
address. DHCP is commonly used with cable modems.
Select PPPoE if your ISP requires a username and password to
establish a connection and assign a dynamic address. PPPoE is
commonly used with DSL modems.