Fujitsu LifeBook S710 User Manual page 96

Hide thumbs Also See for LifeBook S710:
Table of Contents

Advertisement

Available languages

Available languages

Problem
You have installed a USB
device. Your LIFEBOOK
notebook does not recog-
nize the device, or the
device does not seem to
work properly.
(continued)
ExpressCard Problems
A card inserted in the
ExpressCard slot does not
work or is locking up the
system.
Power Failures
You turn on your LIFE-
BOOK notebook and noth-
ing seems to happen.
Possible Cause
Possible Solutions
In Windows Vista, you
(Microsoft Windows Vista users only): When attaching a USB
must either have any
device, do one of the following: Be sure to attach the device
USB device connected
BEFORE turning on your system, OR, wait for approximately
before booting or wait a
three minutes after the system boots up before attaching the
few minutes after boot-
device.
ing before connecting
If you prefer not to wait the prescribed time to connect your USB
it.You must wait a few
device, you must disable the Selective Suspend feature. To do so,
minutes
go to Start > Control Panel. In the left panel, select Classic view.
Click on Power Options > Change plan settings > Change
advanced power settings. Select USB settings, then select Dis-
abled from the pull-down menu for USB selective suspend setting.
Click [OK] to complete the process.
The card is not properly
Remove and re-install the card. See "ExpressCards™/Smart
installed.
Cards" on page 73.
The card may have
Close the application and restart your notebook.
been installed while an
application was running,
so your notebook is not
aware of its installation.
Your software may not
See your software documentation and activate the correct driver.
have the correct soft-
ware driver active.
You may have the
See your PC Card/ExpressCard documentation to determine the
wrong I/O address
required I/O address. Change the settings in the Device Manager.
selected for your card
device.
The primary battery is
Use the Status Indicator panel to verify the presence and condition
installed but is faulty.
of the batteries. See "Status Indicator Panel" on page 22. If a bat-
tery is indicating a short, remove that battery and operate from
another power source or replace that battery.
90

Advertisement

Chapters

Table of Contents
loading

Table of Contents