Lubrication; Transmission; Wheel And Deck Zerks; Front Wheel Mount - Husqvarna RZ4221TF Operator's Manual

12/12 Every year
1/52 Every Week
1/365 Every day
General
Remove the ignition key to prevent unintentional movements
during lubrication.
When lubricating with an oil can, it must be filled with engine
oil.
When lubricating with grease, unless otherwise stated, use a
high grade molybdenum disulphide grease.
For daily use, the machine should be lubricated twice weekly.
Wipe away excess grease after lubrication.
It is important to avoid getting lubricant on the belts or the
drive surfaces on the belt pulleys. Should this happen, attempt
to clean them with spirits. If the belt continues to slip after
cleaning, it must be replaced. Gasoline or other petroleum
products must not be used to clean belts.
IMPORTANT INFORMATION Use minimal lubrication
and remove excess lubricant so that is does not come into
contact with belts or belt pulley drive surfaces.

Transmission

The transmission is maintenance free with no need for level
checks or oil changes. If a leak occurs, replace the unit or
contact your Husqvarna dealer.

lUBRICATIoN

Lubricate with
grease gun
Filter change
Oil change
Level check

Wheel and Deck Zerks

Use only good quality bearing grease.
Grease from well-known brand names (petrochemical
companies, etc.) usually maintains a good quality.

Front Wheel Mount

Lubricate 3-4 strokes with a grease gun on each set of wheel
bearings.

Front Wheel Bearings

Lubricate 3-4 strokes with a grease gun on each set of wheel
bearings.

Deck Spindles

Lower the cutting deck completely. Lubricate with a grease
gun, 2-3 strokes per spindle through the openings in the belt
shields.
If a grease gun without rubber hose is used, the foot plate
must be removed to access the center spindle.
29