Adjusting The Projected Image - BenQ Joybee GP2 User Manual

Adjusting the projected image

Adjusting the image height
The projector is equipped with 1 adjuster foot. This adjuster changes the image height. To
adjust the projector:
1. Screw the adjuster foot to adjust the image
height.
To retract the foot, screw the adjuster foot in a
reverse direction.
If the projector is not placed on a flat surface or
the screen and the projector are not
perpendicular to each other, the projected image
becomes trapezoidal. To correct this situation, see
"Correcting keystone" on page 35
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes.
• Be careful when you screw the adjuster foot as it is close to the exhaust vent where hot air
comes from.
Fine-tuning the image clarity
1. Rotate the focus ring to sharpen the image.
Auto-adjusting the image
In some cases, you may need to optimize the picture quality.
• Using the remote control
Press Auto.
Within 3 seconds, the built-in Intelligent Auto
Adjustment function will re-adjust the values of
Frequency and Clock to provide the best picture
quality.
The current source information will be displayed
in the upper left corner of the screen for 3
seconds.
This function is only available when PC signal (analog RGB) is selected.
34
Operation
for details.