Maintenance; Transporting And Storing Outboard Motor; Clamp Screw Mounting Models - Yamaha F8C Owner's Manual

EMU2822A
Transporting and storing out-
board motor
EWM02620
WARNING
USE CARE when transporting fuel tank,
G
whether in a boat or car.
DO NOT fill fuel container to maximum
G
capacity. Gasoline will expand consider-
ably as it warms up and can build up
pressure in the fuel container. This can
cause fuel leakage and a potential fire
hazard.
Leaking fuel is a fire hazard. When trans-
G
porting and storing the outboard motor,
disconnect the fuel line from the out-
board motor to prevent fuel from leak-
ing.
Never get under the outboard motor
G
while it is tilted. Severe injury could oc-
cur if the outboard motor accidentally
falls.
Do not use the tilt support lever or knob
G
when trailering the boat. The outboard
motor could shake loose from the tilt
support and fall. If the outboard motor
cannot be trailered in the normal run-
ning position, use an additional support
device to secure it in the tilt position.
ECM02440
NOTICE
When storing the outboard motor for pro-
longed time, fuel must be drained from the
fuel tank. The deteriorated fuel could clog
the fuel line causing engine start difficulty
or malfunction.
When storing or transporting the outboard
motor, make sure to follow the procedure list-
ed below.
Disconnect the fuel line from the outboard
G
motor.
Tighten the fuel tank cap and its air vent
G
screw.
When the outboard motor is tilted pro-
G
longed time for mooring or trailering the
boat, disconnect the fuel line from the out-
board motor. Tighten the fuel tank cap and
its air vent screw.
The outboard motor should be transported
and stored in the normal running position. If
there is insufficient road clearance in this po-
sition, then trailer the outboard motor in the tilt
position using a motor support device such as
a transom saver bar. Consult your Yamaha
dealer for further details.
EMU28236

Clamp screw mounting models

When transporting or storing the outboard
motor while removed from a boat, keep the
outboard motor in the attitude shown.

Maintenance

38