Product Specific Problems - Dell 2707WFP User Manual

Wrong Color Picture color not
good
Image retention from Faint shadow from
a static image left on the static image
the monitor for a long displayed appears
period of time on the screen
Video Problems
COMMON WHAT YOU EXPERIENCE
SYMPTOMS
No Video No signal indicator is displayed
Low Quality DVD Picture not crisp and some color
playback distortion
Blinking Video Video is blinking or discontinuous
NOTE: When choosing S-Video, Composite or Component video, Auto Adjust

Product Specific Problems

SPECIFIC SYMPTOMS
Screen image is too small
Cannot adjust the monitor with the
buttons on the front panel
The monitor will not go into
power saving mode.
No Input Signal when user
controls pressed
Change the color to "PC Custom Color" or "MAC Custom Color"
l
Adjust R/G/B value of "PC Custom Color" or "MAC Custom Color"
l
Change the Color Format to "PC RGB" or "YPbPr" (for Video/DVI-HD inputs)
l
Use the Power Management feature to turn off the monitor at all times when not in use
l
Alternatively, use a dynamically changing screen saver
l
l
l
l
l
WHAT YOU EXPERIENCE
Image is centered on screen, but does not fill entire
viewing area
OSD does not appear on the screen
No picture, the LED light is green. When press "+", "-
" or "Menu" key, the message " No S-Video input
signal ", " No Composite input signal " or " No
Component input signal " will appear.
No picture, the LED light is green. When press "+", "-
" or "Menu" key, the message " No S-Video input
signal ", " No Composite input signal " or " No
Component input signal " will appear.
POSSIBLE SOLUTIONS
Check Video Input Selection
Composite: Yellow colored RCA jack
¡
S-Video: Typically a round 4 pin jack
¡
Component: Red, Blue, Green colored RCA
¡
Check DVD connection
Composite gives good picture
¡
S-Video gives better picture
¡
Component: Red, Blue, Green colored RCA jacks
¡
Check DVD connection
Composite gives good picture
¡
S-Video gives better picture
¡
Component: Red, Blue, Green colored RCA
¡
Check if DVD player is HDCP compliant.
Some non-compliant players may exhibit blinking video and others will display a
¡
raster scree
function is not available.
POSSIBLE SOLUTIONS
Perform monitor reset on "Factory Reset"
l
Turn the monitor off and unplug the power
l
cord and then plug back and power on
Move mouse or hit any key on the keyboard
l
on the computer or activate video player,
then access the OSD to set Audio to " off "
state.
Check the signal source. Make sure the
l
computer is not in power saving by moving
mouse or pressing any key on the keyboard.
Check to make sure Video Source to S-
l
Video, Composite or Component is powered
and playing video media.
Check whether the signal cable is plugged in
l
and seated properly. Re-plug the signal cable
if necessary.
Re-boot the computer or video player.
l
jacks
jacks