Cisco MDS 9020 Configuration Manual page 6

Initial Setup Routine
S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
Enter yes (no is the default) to create additional accounts.
Step 4
Note
Create another login account (yes/no) [n]: yes
While configuring your initial setup, you can create an additional user account (in the network-admin
role) besides the administrator's account. See the
information on default roles and permissions.
Enter the user login ID.
a.
Enter the user login ID: user_name
Enter the user password.
b.
Enter the password for user_name: user-password
Confirm the password for user_name: user-password
c. Enter the user role.
Enter the user role [network-operator]:network_admin
Step 5 Enter yes (no is the default) to configure the read-only or read-write SNMP community string.
Configure read-only SNMP community string (yes/no) [n]: yes
a. Enter the SNMP community string.
SNMP community string: snmp_community
Enter a name for the switch.
Step 6
Note
Enter the switch name: switch_name
Enter yes (yes is the default) to configure out-of-band management.
Step 7
Continue with Out-of-band (mgmt0) management configuration? [yes/no]: yes
Enter the mgmt0 IP address.
a.
Mgmt0 IP address: ip_address
Enter the mgmt0 subnet mask.
b.
Mgmt0 IP netmask: subnet_mask
Enter yes (yes is the default) to configure the default gateway (recommended).
Step 8
Configure the default-gateway: (yes/no) [y]: yes
Enter the default gateway IP address.
a.
IP address of the default-gateway: default_gateway
Step 9 Enter yes (yes is the default) to enable Telnet service.
Enable the telnet service? (yes/no) [y]: yes
Cisco MDS 9020 Fabric Switch Configuration Guide and Command Reference
3-6
Only the admin user name can create or modify user accounts.
The switch name is limited to 32 alphanumeric characters.
Chapter 3
"Role-Based Authorization" section on page 9-5
Initial Configuration
for
OL-6988-02