Observe The System Startup And Perform A Basic Configuration; Start The Router - Cisco 7301 Quick Start Manual

Switch the circuit breaker to the ON position.
Step 7
Press the power switch to turn on the router.
Step 8
After powering off the router, wait a minimum of 30 seconds before powering it on again.
Note

Observe the System Startup and Perform a Basic Configuration

Check conditions prior to system startup:
Step 1 Check that all hardware parts and cables are securely attached to the chassis.
Step 2 Check that port adapter configuration information is available, if needed.
Check that a CompactFlash Disk is installed.
Step 3
Check that the console terminal is turned on.
Step 4

Start the Router

The DC return connection to this system is to remain isolated from the system frame and chassis (DC-I).
Caution
Step 1 Place the power switch in the ON (|) position.
Listen for the fans; they should be operating as soon as power is turned on. The following table provides information
Step 2
about the LEDs as the system starts.
Figure 18 Identifying LEDs and LED Status
GI GA BI T ET
HE RN ET 0/0
RJ 45 EN
GI GA BI T ET
LIN K
HE RN ET 0/1
RJ 45 EN
TX
GB IC
RX GI GA BI T ET
LIN K
TX RJ 45 EN
GB IC
RX
C IS C O 7
3 0 1
1
3
5
2
4
6
No. LED Label LED
1
LINK (0/0) LINK (0/0)
2
RJ-45 EN (0/0) RJ-45 enable (0/0) Green
3
LINK (0/1) LINK (0/1)
4
RJ-45 EN (0/1) RJ-45 enable (0/1) Green
5
LINK (0/2) LINK(0/2)
18
HE RN ET 0/2
LIN K
AU X
CO NS OL E
TX
GB IC
RX
AL AR M
CO MP AC T
FL AS H
ST AT US
7
Color
Green
Green
Green
10 0- 24 0V
, 2A , 50 /6
0 Hz
24 V= 9A ,
48 - 60 V=
5A
LED flashes when
Status there is traffic
— Yes
In the Power Up state, No, remains
the LED is On constantly on
— Yes
In the Power Up state, No, remains
the LED is On constantly on
— Yes