Advertisement
OPERATION IN BRIDGE MODE
The Model 952
amplifier must use an external pre-amp or crossover to be used
©
as bridgeable amplifiers. One channel of the inputs of this amplifier must receive
an inverted signal in order to have the needed inverted signal on one channel at
the output. Speaker connection can then be made from LEFT (+) and RIGHT (+).
(See diagram on next page)
BRIDGED MODE OPERATIONAL DIAGRAM
GENERAL TROUBLESHOOTING
NO SOUND: Check all connections. Check main power fuse. Check accessory
fuse of your vehicle. Check to see that +12Vdc is present at the amplifier on the
power wire, and on the red/white remote turn-on wire. Check for a solid ground
connection. Check that the main music source is putting out signal.
BLOWS FUSES: Check all connections to be sure no wires are touching each
other or the chassis of the vehicle or any other equipment in your install. Check
that your speakers are in proper working order.
SHUTS OFF: These amplifiers are equipped with a Thermal Shutdown System.
If the amplifier becomes too hot during operation, it will shutdown until it cools to
proper operating temperature. This can be caused by lack of proper air
circulation to the amp, or too low of speaker impedance.
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
6
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
