Advertisement
3 CHANNEL OPERATION:
STEREO PLUS SINGLE SUBWOOFER
To build a single amp system with two satellites and a subwoofer, configure the
amplifier outputs as follows: Using 4-ohm satellite speakers, hook them up for
normal stereo operation as described above. Then, using a 4-ohm subwoofer
speaker, hook it up using the two CENTER connections on the terminal strip.
Follow the polarity of the strip as described in the section above. A second set of
satellites may be added for 2-ohm operation. (See diagram on next page)
3-CHANNEL OPERATIONAL DIAGRAM
© 2008 Linear Power, Inc. - ALL RIGHTS RESERVED
5
LINEAR POWER™ is a trademark of Linear Power, Inc.
Advertisement
