Reports; Cash-In-Drawer Declaration - Samsung ER-290 Setup And Operation Manual

System reports are divided into two basic categories;
"X", or read-only and "Z", or read & reset to zero.
Most reports are available in both categories.
NOTE 11 Refer to REPORT TABLE about report.

6-1. CASH-IN-DRAWER DECLARATION

In System Option Programming (3-1), Cash-In-Drawer Declaration can be
programmed as compulsory.
Cash-In-Drawer Declaration is performed by adding the total of each type of
media in the drawer, and pressing the SUBTOTAL key with numeric key will
enter the information as the Cash-In-Drawer Declaration performed.
After performing this declaration, a report in X and Z position will be allowed.
In this case, the difference of input amount and Cash-In-Drawer is displayed.
* Turn to CONTROL LOCK POSITION X.
Example. You count the money in drawer, 420.00. Perform the Cash-In-Drawer Declaration.
4 2 0
NOTE !! If you do not issue the report in X or Z mode after this declaration,
you can not take any registering operation.
0 0 SUBTOTAL
---- Inputted amount
---- Cash-in-drawer
---- Difference
2 5 - 1 2 - 1 9 9 7
* . . . . 4 2 0 . 0 0 N A
* . . . . 4 2 8 . 4 4 R 1
* . . . . . - 8 . 4 4 N O
* 1 0 0 0 0 4 2
1 5 . 3 3
55

REPORTS

3 0