Marantz NR1604 Owner's Manual page 17

Contents
Q3 Q2 Q1 Q0 o
q w e r t
q
FM antenna terminal (ANTENNA)
Used to connect FM antennas (vpage 41).
w
Analog audio connectors (AUDIO)
Used to connect devices equipped with analog audio connectors
(vpage 36, 37).
e PRE OUT connectors
Used to connect a subwoofer with a built-in amplifier or an external
power amplifier (vpage 25, 27, 30, 122).
r Video connectors (VIDEO)
Used to connect devices
(vpage 34, 36, 37).
t Component video connectors (COMPONENT VIDEO)
Used to connect devices equipped with component video connectors
(vpage 34, 36, 37).
y Speaker terminals (SPEAKERS)
Used to connect speakers (vpage 24).
Front panel Display
Connections Playback
i
y u
equipped with video
Rear panel
Settings
u
AC inlet (AC IN)
Used to connect the power cord (vpage 47).
i HDMI connectors
Used to connect devices equipped with HDMI connectors
(vpage 32, 33, 36, 37).
o Digital audio connectors (DIGITAL AUDIO)
Used to connect devices equipped with digital audio connectors
(vpage 33, 34, 36, 37).
Q0 Network connector (NETWORK)
Used to connect this unit to the network (vpage 42).
Q1 REMOTE CONTROL connectors
Used to connect infrared receivers/transmitters in order to operate this
unit and external devices from a different room (vpage 45).
Q2 M-XPort connector
Used to connect to a wireless receiver (RX101, sold separately)
(vpage 44).
Q3 DC OUT jack
Used to connect devices equipped with the trigger function
(vpage 46).
connectors
NOTE
• Do not touch the inner pins of the connectors on the rear panel. Electrostatic
discharge may cause permanent damage to the unit.
17
Remote
Tips Appendix
Index