Table of Contents
Advertisement
Antitheft Alarm Function
How to install the battery
To use the Antitheft alarm function, you need to install a
battery into the projector. (Use a SANYO Electric Co., Ltd.
CR2 3V lithium battery.)
Unplug the AC power cord from a wall outlet before
installing the battery. Remove the screw and open the
battery cover on the bottom of the projector.
When the battery is installed properly, the ALARM indicator
blinks for about 10 seconds. After placing the battery, put
the cover back and secure it with the screw.
When the battery comes to the end of its life, the ALARM
indicator flashes and the warning sound is produced at
some intervals.
Replace the battery by following the procedures above.
✔
Notes:
•The PIN code and settings you have changed are effective even
after the battery is changed.
•When changing the battery, set the Antitheft alarm function to
"Off." Otherwise the alarm starts ringing as you try to open the
battery cover.
To insure safe operation, please observe the following precautions:
● Do not keep the battery mixing with wire or metal products to avoid causing a short.
● Keep the battery away from babies and children to prevent them from swallowing it.
● Do not charge the battery.
● Do not disassemble or apply pressure to transform the battery.
● Avoid contact with water or liquid matter.
● Do not expose to moisture or heat.
● If the battery has leaked, carefully wipe the battery compartment clean and install new battery.
● Do not replace the battery with an incorrect type or in an incorrect direction.
● Dispose of used battery after insulating the battery by putting an insulating tape on either or both
sides of the top/bottom of the battery.
● Dispose of used battery by following the local regulations.
52
Screw
Loosen the screw and
open the battery cover.
Install the battery, then put back the
battery cover and secure it with the
screw.
Advertisement
Table of Contents
