Table of Contents
Advertisement
Setting
On start
When this function is set to "On," the projector is
automatically turned on just by connecting the AC power
cord to an outlet.
✔
Note:
•Be sure to turn the projector off properly (see "Turning Off the
Projector" on page 20). If the projector is turned off in the incorrect
sequence, the On start function does not operate properly.
Lamp control
You can change the brightness of the screen.
Normal .... Normal brightness
Auto ........ Brightness according with the input signal
Eco .......... Lower brightness reduces the lamp power
consumption and extends the lamp life.
Remote control
This projector provides two different remote control codes;
the factory-set, initial code (Code 1) and the secondary code
(Code 2). This switching function prevents remote control
interference when operating several projectors or video
equipment at the same time.
When operating the projector in "Code 2," both the
projector and the remote control must be switched to
"Code 2."
To change the code for the projector:
Select either "Code 1" or "Code 2" in this Setting Menu.
To change the code for the remote control:
Press and hold both the MENU and IMAGE buttons
together for more than 10 seconds. After changing the
code, make sure the remote control operates properly.
✔
Notes:
•When different codes are set on the projector and on the remote
control, any operation cannot be made. In that case, switch the
code on the remote control to fit the code on the projector.
•When the batteries of the remote control are replaced, the remote
control code automatically returns to the initial code (Code 1).
46
On start
Remote control
Press and hold
MENU and
IMAGE buttons
for more than 10
seconds.
Advertisement
Table of Contents
