Table of Contents
Advertisement
Resetting the microprocessor (Factory Reset)
When the microprocessor is reset, all the settings are reset to their default values.
1
Press and hold
for more than 3 seconds.
Settings
2
Press + or – to select "Factory Reset", then press 13.
Factory Reset
3
Press + or – to select "Reset Factory Defaults", then press 13.
"Resetting..." is displayed and the default settings are restored.
If "Resetting..." does not display in step 3, start over from step 1.
n Exiting the menu to return to the normal mode
Press
until the input source is displayed.
• The unit exits the setting mode and the normal display returns.
How to reset
"Reset" is an operation that restarts this unit. Perform the reset in cases such as when the display does
not function properly or you are unable to operate this unit. The existing settings will remain intact.
When the power of this unit is on, insert a thin stick
or a needle (z2) into the reset hole (z1), and press the
reset button within this unit.
AC IN
This unit automatically restarts.
• Prepare a thin stick or a needle (such as a toothpick or a
straightened paper clip) for pressing the reset button within
this unit.
z 1 Thickness (dia.): 0.5 mm – 1.5 mm
z 2 Length: 30 mm or longer
USB
NETWORK
WIRELESS LAN
LOUDNESS ON / STANDBY
5V 0.5A
AUX IN
NETLINK
WPS
z1
Specifications
n Audio section
• Amplifiers:
4 x 25 W ClassD
• Speakers:
4 cm Tweeter x 2
10 cm Woofer x 2
n Wireless LAN
Network type
Conforming to IEEE 802.11b
Conforming to IEEE 802.11g (Conforming to Wi-Fi ® )z
(wireless LAN standards):
Transfer rate:
DS-SS: 11 / 5.5 / 1 Mbps (Automatic switching)
OFDM: 54 / 48 / 36 / 24 / 18 / 12 / 9 / 6 Mbps (Automatic switching)
Security:
SSID (Network name)
WEP key (network key) (64/128 bits)
WPA-PSK (TKIP/AES)
WPA2-PSK (TKIP/AES)
Used frequency range:
2412 MHz – 2472 MHz
No. of channels:
Conforming to IEEE 802.11b : 13ch (DS-SS) (Of which 1 channel is used)
Conforming to IEEE 802.11g : 13ch (OFDM) (Of which 1 channel is used)
n General
Power supply:
AC 100 – 240 V, 50/60 Hz
Power consumption:
50 W
Power consumption in standby mode:
0.5 W
Power consumption in
"Network Control" – "On" mode:
5.5W
z Wi-Fi ® conformity indicates tested and proven interoperability by the "Wi-Fi Alliance", a group certifying
interoperability among wireless LAN devices.
For purposes of improvement, specifications and design are subject to change without notice.
33
Hide quick links:
Advertisement
Table of Contents
