Wps (Wi-Fi Protected Setup) - EnGenius 11N Wireless Gigabit Multi-Function Client Bridge User Manual

Multi-Function Gigabit Wireless-N Client Bridge Version 1.0
ESSID Selection: As this device supports multiple SSIDs, it is possible to configure
a different security mode for each SSID (profile). Select an SSID from the drop-down
list.
Broadcast SSID: Select Enable or Disable from the drop-down list. This is the SSID
broadcast feature.
When this option is set to Enable, your wireless network name is
. If you're not using encryption then
broadcast to anyone within the range of your signal
they could connect to your network. When this is disabled, you must enter the
Wireless Network Name (SSID) on the client manually to connect to the network.
WMM: Choose to Enable or Disable WMM. This is the Quality of Service (QoS)
feature for prioritizing voice and video applications. This option can be further
configured in WMM under the Wireless drop-down menu.
Encryption: Select WPA pre-shared key from the drop-down list.
WPA Mode: Select the Auto WPA / WPA2 from the drop-down list.
WPA Type: Select TKIP, AES, or WPA2 Mixed. The encryption algorithm used to
secure the data communication. TKIP (Temporal Key Integrity Protocol) provides
per-packet key generation and is based on WEP. AES (Advanced Encryption
Standard) is a very secure block based encryption. Note that, if the bridge uses the
AES option, the bridge can associate with the access point only if the access point is
also set to use only AES.
RADIUS Server IP Address: Specify the IP address of the RADIUS server.
RADIUS Server Port: Specify the port number of the RADIUS server, the default
port is 1812.
RADIUS Server Password: Specify the pass-phrase that is matched on the RADIUS
Server.
Click on the Apply button to save the changes.

3.2.5.2.5 WPS (Wi-Fi Protected Setup)

Click on the WPS link under the Wireless drop-down menu
WPS requires you to enter a PIN for the device press the configuration button on the
device. If the device supports Wi-Fi Protected Setup and has a configuration button,
you can add it to the network by pressing the configuration button on the device
There are several ways to add a wireless device to your network. Access to the
wireless network is controlled by a registrar. A registrar only allows devices onto the
wireless network if you have entered the PIN, or pressed a special Wi-Fi Protected
24