ProForm PRO 2000 User Manual page 4
Treadmill
Hide thumbs
Also See for PRO 2000:
- User manual (36 pages) ,
- User manual (40 pages) ,
- User manual (44 pages)
Table of Contents
Advertisement
20. Never leave the treadmill unattended while
it is running. Always remove the key, unplug
the power cord, and press the power switch
into the off position when the treadmill is not
in use. (See the drawing on page 5 for the
location of the power switch.)
21. Do not attempt to raise, lower, or move the
treadmill until it is properly assembled. (See
ASSEMBLY on page 7, and HOW TO FOLD
AND MOVE THE TREADMILL on page 25.)
You must be able to safely lift 45 lbs. (20 kg)
to raise, lower, or move the treadmill.
22. When folding or moving the treadmill, make
sure that the storage latch is holding the
frame securely in the storage position.
23. Never insert any object into any opening on
the treadmill.
24. Inspect and properly tighten all parts of the
treadmill regularly.
SAVE THESE INSTRUCTIONS
DANGER:
25.
cord immediately after use, before clean-
ing the treadmill, and before performing the
maintenance and adjustment procedures
described in this manual. Never remove the
motor hood unless instructed to do so by an
authorized service representative. Servicing
other than the procedures in this manual
should be performed by an authorized ser-
vice representative only.
26. This treadmill is intended for in-home use
only. Do not use this treadmill in a commer-
cial, rental, or institutional setting.
27. Over exercising may result in serious injury
or death. If you feel faint or if you experience
pain while exercising, stop immediately and
cool down.
4
Always unplug the power
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the PRO 2000 and is the answer not in the manual?
Questions and answers
1142-FP66J66C Pro-Form treadmill My Treadmill has stopped working after several months. When the screen comes up it says retry. I don't use it on the internet only manual. It has been working until yesterday and it only comes up with retry at bottom of page and when I tap it only stays on. I can tap at top of page and nothing comes up
first time trying to use my treadmill after several years. It is not responding to start command
The ProForm PRO 2000 treadmill may not respond to the start command due to the following reasons:
1. The power switch may have tripped. Press it into the off position, wait five minutes, then press it back in.
2. The power cord may be unplugged. Unplug it, wait five minutes, then plug it back in.
3. The key may not be properly inserted into the console. Remove the key, then reinsert it.
If the treadmill still does not start after these steps, further troubleshooting may be needed.
This answer is automatically generated