Testing All Burglary Sensors - ADT BHS-4000A User Manual

Testing All Burglary Sensors

This test helps to ensure that the system's burglary sensors are working properly. No alarm signal is sent to ADT's
Customer Monitoring Centers.
* If the system uses four-digit codes, press 2, 4, 7, then press and hold the 0 key for
three seconds.
Standard Keypad
1. Make sure there is
nothing moving near
the motion detector and
that the READY light is
on. (If it is not, see page
29.)
2. Press the OPTIONS key.
3. Press the 2 key.
The ENTER CODE
light blinks.
4. Press 2, 4. Then press
and hold the 7 key for
three seconds.*
5. Open each protected
door and window. Listen
for the siren to blast.
Close the door or
window.
6. Walk in front of the
motion detector. The
siren blasts each time
the motion detector
detects your movements.
(continued)
26
Premium Keypad
1. Make sure there is
nothing moving near
the motion detector
and that the message
window reads READY.
(If it does not, see page
29.)
2. Press the OPTIONS
key until the message
window reads DOOR
CHIME.
3. Press 2, 4. Then press
and hold the 7 key for
three seconds.*
The message window
reads READY DOOR
CHIME TEST.
4. Open each protected
door and window.
Listen for the siren to
blast. Close the door
or window.
5. Walk in front of the
motion detector. The
siren blasts each time
the motion detector
detects your move-
ments.