Quadra-Fire QV32B-A Owner's Manual page 56

Install the Log Assembly
If the gas logs have been factory installed they should not
need to be positioned. If the logs have been packaged
separately, refer to the following instructions.
4
5
STEP 1: Carefully remove the logs from the packaging.
CAUTION: Logs are fragile!
STEP 3: LOG #2 (SRV2014-703): Place log #2 with the
left tip of the log on the fl at spot on the burner. Pull the right
part of the log to touch right grate tine, and the top of the log
should rest against log #1.
STEP 5: LOG #4 (SRV780-707): Place log #4 across log #1
and log #2 with burned out area facing out.
56
1
2
3
SAME SAME
2
4
1
2
Quadra-Fire • QV32B-A, QV36B-A • 2014-900 Rev. U • 1/12
Log Set Assembly: LOGS-2016
STEP 2: LOG #1 (SRV2016-701): Place notches of log #1
LOG LOG
on outer two grate tines, and push against back of fi rebox.
3
STEP 4: LOG #3 (SRV2014-703): (This log is the same as
log #2). Place log #3 with the fl at side down and burned side
into notch on burner. Pull left end forward against grate.
5
3
STEP 6: LOG #5 (SRV700-706): Place log #5 across logs
#1 and #3 with the Y-shape facing out.
Model: QV36B-A
1
1
2016-925B 6/03