Fine Tuning The Polaris Cleaner; Sweep Hose Adjustment; Routine Maintenance; Cleaning The Filter Bag - Polaris Vac-Sweep 180 Owner's Manual

Hide thumbs Also See for Vac-Sweep 180:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

Fine Tuning The Polaris Cleaner

D place l unit vers la gauche
When operating correctly, the Polaris 180 vacuums, sweeps and scrubs all surfaces
Dr ckt Ger t Nach Links
randomly throughout the pool. Approximately every 3 minutes the Polaris 180 goes into
Empuja la unidad hacia la izquierda
back-up mode. This action pulls the Polaris away from pool obstacles and increases its
Spinge l unit a sinistra
Empurra a unidade para a esquerda
random pattern.

Thrust Jet Adjustment

The thrust jet powers the direction of the Polaris.
D place l unit vers la droite
Factory position is straight back, but depending
Dr ckt Ger t nach rechts
Empuja la unidad hacia la derecha
on the pool, other settings are helpful.
Spinge l unit a destra
Empurra a unidade para a direita

Sweep Hose Adjustment

The sweep hose should move in a gentle sweeping
motion. To adjust, turn off the booster pump and turn
Augmente la force de grimpe
the sweep hose adjustment screw. Turn clockwise to
decrease the motion.
Aumenta la ascensi n

Routine Maintenance

Diminue la force de grimpe

Cleaning the Filter Bag

Disminuye la ascensi n
Remove the bag from the cleaner. Open the bag closure and dump out the debris.
Empty the filter bag
when it is half full,
especially if the dirt
load is sand.
It is easier to empty
the bag when it is dry.
Alternate between
two bags.

Backwashing the Pool Filter

Always disconnect the Polaris from the pool wall before cleaning or backwashing the pool
filter. After cleaning or backwashing, let the filtration system run for at least five minutes to
flush out the return lines before re-connecting the Polaris.

Storage and Winterizing

Never store the Polaris in direct sunlight. When storing for the winter, drain out all the water
(freeze damage is not covered under the warranty). Remove the UWF from the pool wall by
attaching the Quick Disconnect and using pulling pressure to unscrew. In some cases, it may
be necessary to use the UWF Removal Tool (part #10-102-00) available from an authorized
Polaris dealer.
Pushes Unit Left
Pushes Unit Right
Increases Climbing
Erh ht Steigung
Aumenta la salita
Aumenta a subida
Decreases Climbing
Verringert Steigung
Diminuisce la salita
Diminui a subida
For on-line support: www.polarispool.com
12
9
3
6
Velcro
Closure

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents