Zr2740W Model - HP ZR2040w User Manual

ZR2740w Model

For the ZR2740w model, the default input is DisplayPort. You can change the current input by
pressing the SOURCE button on the front of the panel.
The front buttons also let you adjust brightness and put the monitor in low-power mode:
Figure 3-3
Control
1 SOURCE
2 -
3 +
4
5
Holding down either the
you reach either the minimum or maximum brightness, the LED will flash three times.
26 Chapter 3 Operating the Monitor
ZR2740w Front Panel Controls
Source
Minus
Plus
Power
Power LED
+ or — button causes the brightness setting to change more rapidly. When
Function
Toggles the video signal input source between DisplayPort
and DVI-D.
Decreases brightness.
Increases brightness.
Turns the monitor on or off as long as the master power
switch on the rear panel is on.
Solid blue indicates the first 30 seconds of normal
operation.
Solid amber indicates low-power mode.
Continuously-flashing blue indicates signal input in a non-
supported mode. (See ZR2740w Model Preset Modes
on page 36 for supported modes.)
Three blue flashes while you are adjusting brightness
indicate the limit of the screen's brightness range.
No light indicates normal operation or power off.