Pfaff Creative 4.0 Owner's Manual page 43

Cut jump stitches
Your machine features the automatic function
Cut jump stitches. This function saves you time
trimming after the embroidery is completed.
When Cut jump stitches is selected your machine
will trim the top jump stitch thread and pull the
thread end to the underside of the fabric as you
embroider.
Note: Your machine will also cut the thread after you
have changed to a new color. Hold the thread end when
you start embroidering again, so that you can easily
remove the thread end when cut.
Designs marked "Cut jump stitch trim
command" are programmed for Cut jump
stitches. Jump stitch trim commands can
be added to any design using the 5D™ Organizer
Software, included with your machine. Go to File and
select Add Trim Command.
Timer
Displays the total sewing and embroidery time of
your machine. Touch the icon to reset the timer.
Automatic thread snips
When selected, the automatic thread snips is
activated. The threads are cut automatically and
the presser foot raises at color changes or when
an embroidery is nished. When deselected, no
automatic thread snips will be performed.
Automatic presser foot lift
When selected, the automatic presser foot lift is
activated. The presser foot will raise to pivot height
for example when stopping to sew with the needle
in the down position. When deselected, the presser
foot will stay lowered even if the machine stops
with the needle in down position.
Defragment machine memory
To optimize the sewing and embroidery
performance you sometimes need to do a
defragmentation. When that needs to be done a
pop-up message appears. To defragment your
machine rst remove unneccesary les then go
to the Machine Settings in the Settings menu and
select Defragment machine memory.
The defragmentation can take up to 45 minutes.
A B
Pop-up for defragmentation
C
3:9