Table of Contents
Advertisement
CARE AND CLEANING
Before your maintenance starts, disconnect the power plug or disconnect power and shut the water
valves off.
Solvents are forbidden to avoid damaging the washing machine and generating toxic gases
which can explode.
Never spray water on the washing machine to clean it.
It is forbidden that detergents containing PCMX are used to clean the washing machine.
Cleaning and Maintenance of Washing Machine Cabinet
Proper maintenance on the washing machine can extend its working life. The surface can be cleaned
with diluted non-abrasive neutral detergents when necessary. If there is any water overflow, use a wet
cloth to wipe it off immediately. No sharp items are allowed to strike the cabinet.
Note: formic acid and its diluted solvents or equivalent are forbidden.
Clean Internal Drum
Any rust left inside the drum by metal articles must be removed immediately with chlorine-free deter-
gents. Never use steel wool.
Avoid Machine Damage from Freezing
If your washing machine is located in the room where it can get frozen easily, please drain the remain-
ing water inside drain pipe and inlet pipe thoroughly. Damages not covered under warranty.
Thaw Out a Frozen Washing Machine
When the temperature drops below 32° F (0° C) and your washing machine will freeze, you must:
1.
Disconnect the power supply for the washing machine.
2.
Wash the tap with warm water to loosen inlet pipe.
3.
Take down inlet pipe and immerse it in warm water.
4.
Pour warm water into washing drum and wait for 10 minutes.
5.
Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally.
Notes: when the washing machine is reused, make sure the ambient temperature is above 32°F (0°C).
Remove the remaining water in inlet pipe:
1.
Close the tap.
2.
Screw off the inlet pipe from tap and put its end into the
container.
3.
Start up any procedure except single Wash or Drain proce-
dure.
4.
Water will be drained out of inlet pipe if any for about 40
seconds.
5.
Reconnect the inlet pipe to tap.
Remove the remaining water in drain pump
Burn Hazard!
It should be done after the hot water inside the machine cools down.
Clean detergent box and grooves
Clean detergent drawer and grooves
1.
Press down the arrow location on softener cover inside the
drawer.
2.
Lift the clip up and take out softener cover and wash all
grooves with water.
3.
Restore the softener cover and push the drawer into position.
20
INSTALLATION REQUIREMENTS
Appliance Dimen-
41½"
(105cm)
The dimensions shown are for the minimal spacing. Custom under counter installation
2" (5cm)
33½"
(85cm)
1" (2.5cm)
Unpacking the Appliance
Unpack your washing machine and check if there is any damage during the transportation. Also make
sure that all the items included (as shown in Page 7) in the attached bag are received. If there is any
damage to the washing machine during the transportation, or any item is missing, please contact the
local dealer immediately.
Disposal of Packing Materials
The packing materials of this machine may be dangerous to children. Please dispose of them
properly and avoid easy access by children. Please dispose the related packing materials
according to the relevant local regulations.
sions
23½"
(60cm)
33½"
(85cm)
21½"
(55cm)
23½"
1" (2.5cm)
(60cm)
9
Hide quick links:
Advertisement
Table of Contents
