Table of Contents
Advertisement
OPERATING INSTRUCTIONS
Selecting the Wash Cycle
Heavily Soiled, pure white co on or flax (for exam‐
Extra Hot
ple: coffee table cloths, canteen table cloths, towels,
bed sheets)
Moderately Soiled, colorful flax, co on and syn‐
Hot
the c ar cles with certain color fade degree (for
example: shirts, night pajamas)
Warm
Normal Soiled ar cles (including synthe c and wool)
The proper wash cycle must be selected according to the types, quantities, and soil level of the clothes
to be washed in combination with the following washing temperature table.
I.
First, turn the rotary switch to select the corresponding procedures according to the types of
textiles.
II.
Second, select the proper temperature according to the soil level. Generally, the higher the tem-
perature is, the more power consumed.
III.
Third, select the proper revolution speed. The higher the revolution speed is, the drier the textiles
are spun, with faster spinning .
Add Garment
This operation can be executed during the washing procedure.
When the drum of the washing machine is still rolling and there is large amounts of very hot water
present. DO NOT attempt to open the door, it is dangerous and could result in property damage or
serious personal injury.
If inside temperature exceeds 122 ° F the door will not open, you must wait until it cools below this
temperature.
18
INSTALLATION REQUIREMENTS
The minimum carry away capacity can be no less
than 17 gal.(64 L) per minute. The top of the
standpipe must be at least 23.6" (60cm) high and
no higher than 39.4" (100cm) from the bottom of
the washer.
Laundry tub drain system (view C) The laundry
tub needs a minimum 20 gal.(76 L) capacity.
The top of the laundry tub must be at maxi-
mum 39.4" (100cm) above the floor with a
minimum of 23.6" (60cm) .
Floor drain system (view D). The floor drain system
requires an air gap, siphon break that may be pur-
chased separately. See "Tools and Parts". The siphon
break must be a minimum of 28"( 71cm) from the
bottom of the washer. Additional hoses might be
needed.
Fastening and leveling the Appliance
1.
If the template is not placed flush to the back of the installation area to provide the minimum
spacing, measure its location to align the appliance correctly in the cabinet.
2.
Align with template and secure the brackets with screws on the exposed bracket sides. Then
remove the template and finish securing the brackets. Note the slot opening must be facing
toward the front.
3.
Make sure the floor surface is protected
against damage. Slide the appliance and
align the rear legs to the rear bracket slot
openings. Making sure that the legs are
touching or within 1/4" from touching the
back of the slot.
4.
Level the machine using the front legs.
a.
When positioning the washing ma-
chine, first check if the front legs are in
the shortest position that will allow
room for the foot to fit inside the brack-
et. If not, adjust them to their shortest
position with hand or spanner and
tighten the nuts with wrench.
Min 28"
(71cm)
Min 23.6" (60cm)
Max 39.4" (100cm)
TEMPLATE
SCREWS
FLOOR
BRACKETS
11
A
C
D
Hide quick links:
Advertisement
Table of Contents
