Central Pneumatic 61244 Owner's Manual & Safety Instructions page 10

Operating Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this
manual including all text under subheadings therein before set up or use of this product.
Inspect tool before use, looking for damaged, loose, and missing parts.
If any problems are found, do not use tool until repaired.
Tool Set Up
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Turn off the tool, detach the air supply, safely discharge any residual air pressure in the tool, and
release the trigger before performing any inspection, maintenance, or cleaning procedures.
TO PREVENT SERIOUS INJURY:
Do not adjust or tamper with any control or component in a way not specifically explained within
this manual. Improper adjustment can result in tool failure or other serious hazards.
Chisel
Chisel Removal
1. Twist the Spring off the Cylinder using the back hook.
2. Remove the Chisel shank from
the Spring and the Cylinder.
Chisel
Chisel Installation
1. Insert the Chisel shank through the Spring
and into the front of the Cylinder.
2. Twist the Spring onto the threaded front
of the Cylinder using the front hook.
Note: The collar on the chisel must go under
the spring to keep it from falling out.
Page 10
2
Figure C: Chisel Removal
To twist the Spring off, twist from the hook at the back.
Figure D: Chisel Installation
To twist the Spring on, twist from the hook at the front.
For technical questions, please call 1-800-444-3353.
1
Spring
1
2
Spring
Item 61244