Table of Contents
Advertisement
Elite 1500W—Pure Sine Inverter by Wagan Tech
Troubleshooting
PROBLEM: Low or No Output Voltage – Fault LED Lit
Reason
Poor contact with battery or inverter
terminals.
PROBLEM: Inverter is Shut Down – Fault LED Lit
Reason
Battery voltage below 10 Volts
Inverter is too hot (thermal shut down
mode).
Unit may be defective.
PROBLEM: Inverter Shut Down – Fault LED Lit – OVL Display
Reason
Equipment being operated draws too
much power.
15
www.wagan.com
Solution
Clean terminals thoroughly. Reinstall
and tighten.
Solution
Charge or replace battery.
• Allow inverter to cool.
• Check for adequate ventilation.
• Reduce the load on the inverter to
rated continuous power output.
See warranty and call customer
service.
Solution
Use a higher capacity inverter or do
not use this equipment.
User's Manual—Read before using this equipment
PROBLEM: Continuous Buzzing Sound – Display Shows Low Voltage
Reason
Input voltage below 10.5 Volts
Poor or weak battery condition.
Poor or loose cable connection
Inadequate power being
delivered to the inverter or
excessive voltage drop.
Disposal/Recycling of Inverter
Electronic products are known to contain materials that are toxic if improperly
disposed. Contact local authorities for disposal and recycling information.
©2010 Wagan Corporation
Wagan and wagan.com are trademarks used by Wagan Corporation
Solution
Keep input voltage above 10.5 Volts
Recharge or replace battery.
Inspect terminals and tighten all
connections.
• Use heavier gauge DC cable.
• Keep cable length as short as possible.
All Rights Reserved
16
Advertisement
Table of Contents
